LOGGING ON THE SYSTEM

5.0        LOGGING ON THE SYSTEM

6.1       When you first power up the test station, the operating system loads the necessary

software to initialize.  When this “boot-up” process is complete, you will see a log on window similar to that shown in figure 3.

6.2        Trained and certified test operators may log in as user1.  All other operators must log in

as operator.

FIGURE 3

6.2        Type in the appropriate username at the log in screen and click the mouse on the “OK”

button displayed on the screen or press the “ENTER” key on the keyboard.

6.3        The system will then prompt you to enter the proper password for the account that you

are logging in under.  Click the mouse on the “OK” button displayed on the screen or press the “ENTER” key on the keyboard.

6.4        Following the process defined in the Test Department Procedure , SOP-3-1002-9,

identify and locate the In-circuit Test Fixture required for the UUT to be tested.

6.5        Removed the testhead covers as required and install the test fixture.  Unless otherwise

instructed the single bank test fixtures are installed onto bank 2 of the testhead.